No test yet. Select Start to begin.

See the path packets take from each region to your server

No test yet. Select Start to begin.

Select nodes

Traceroute

No hops with location data (the node did not return coordinates)
Responded normally High loss (5%–95%) Severe loss (≥95%) No response

Traceroute path

Receiving
Hop IP address PTR Location / ISP AS Packet loss Last (ms) Best (ms) Worst (ms)
Latency is the round-trip time to each hop. Loss is calculated from the probes sent to each hop. Latency in milliseconds (ms)

Test overview

Target IP
Total hops
Responses
Nodes with loss
Average latency
Test time
Test method
Test node

Route overview

Approx. distance km

Packet loss distribution

Total hops

Latency distribution (responding nodes)

Reading a traceroute

Traceroute lists the hops toward a destination. Compare the latency and loss at each hop with the final destination to see where a problem persists.

Traceroute records every hop between a test node and the destination, with the IP, location, network operator, latency and loss for each hop. When ping shows high latency but not where it comes from, traceroute is the tool that pinpoints the segment.

Look for the hop where latency jumps and stays high for every following hop; that is where the problem starts. A single slow hop followed by normal hops only means that router deprioritizes probe replies. For traffic between China and other countries, the cross-border hops show whether a route uses a premium path such as CN2 GIA or a congested international exit.

Frequently asked questions

Does loss at one hop indicate an outage?

Intermediate routers may rate-limit probe responses. If subsequent hops and the destination respond normally, that isolated loss is usually a response policy.

A hop shows a timeout or asterisk. Is the network down?

Usually not. Many routers do not answer TTL-exceeded probes, so they appear as asterisks. If later hops and the destination respond, the path works. Only when every hop from one point to the destination times out is the path actually broken.

Why does latency not increase hop by hop?

Each hop measures the full round trip from the source to that router, and routers give probe replies different priority. A slow hop followed by a faster one is normal rate limiting and does not affect forwarding.

What is the difference between traceroute and MTR?

Traceroute probes each hop a few times and gives a snapshot. MTR keeps probing and reports loss and latency statistics per hop, which makes intermittent problems easier to find.

This page has expired
The page verification expired. Refresh the page and try again.