No test yet. Select Start to begin.

Ping your target from multiple locations worldwide

No test yet. Select Start to begin.

Global latency distribution

Timeout > 250ms 101ms - 250ms 51ms - 100ms <= 50ms
Timeout > 250ms 101ms - 250ms 51ms - 100ms <= 50ms
Region / ISPFastestSlowestAverage

DNS resolution statistics

Test results

Test node Response IP IP location
Test node Response IP IP location loss Sent Last Fastest Slowest Average Network quality

Reading Ping results

Ping uses ICMP echo requests to measure round-trip time and packet loss. Compare regions and providers to distinguish a local routing problem from a widespread outage.

Ping is a network utility that sends ICMP echo requests to a host and measures the round-trip time (RTT) and packet loss. A ping from your own computer only describes your own route. TCPING.CN sends the same ping from more than 200 nodes worldwide and from China Telecom, China Unicom and China Mobile in many provinces at the same time, then lists the resolved IP, minimum, maximum and average latency and packet loss for every location and colors the map by latency.

To run a test, enter a domain or IP address and select Start. You can also open a shareable result URL directly, for example /en/ping/example.com.

Frequently asked questions

Can a website work when Ping times out?

Yes. A firewall may block ICMP while allowing HTTPS. Use TCPing on port 443 or run an HTTP test to check the service.

What is a normal ping latency?

Within the same city and carrier, 5–20 ms is typical. Across provinces in China, 20–50 ms is normal, and between Chinese carriers 30–80 ms. From China to the US West Coast, expect 150–200 ms, and to Europe 200–300 ms; these limits come from the speed of light and distance. Latency above 250 ms, or a maximum several times the average, is worth investigating.

How much packet loss is a problem?

Under 1% is barely noticeable. 1–5% slows page loads and causes occasional stutter in calls. Above 5%, TCP retransmits often and the experience degrades clearly, and sustained loss above 10% usually means a real fault or rate limiting. Loss at a single intermediate hop with a healthy destination is usually ICMP rate limiting, not a fault.

Why does each location resolve a different IP?

The domain uses a CDN or GeoDNS that returns the nearest edge server for each visitor. That is expected. If a region is sent to a distant server, for example users in China resolving to an overseas IP, check the CDN routing with a DNS lookup.

This page has expired
The page verification expired. Refresh the page and try again.